ER-102

Topic	Replies	Views	Activity
About the ER-102 category	2	388	April 1, 2017
ER-102 dead support	14	259	September 10, 2020
ER-101/102 loop points not working	13	185	August 10, 2020
Can I add whole patterns to a group?	3	91	August 10, 2020
Editing voltage table pitch names	4	120	July 27, 2020
Track-specific user transition of Parts not working support	10	159	July 22, 2020
ER-102: Enabling & disabling Groups request	4	89	July 10, 2020
ER102: Is there a way to disable Low Transforms in Groups via Gate signal? request	10	117	July 6, 2020
Copy group step selection WITHOUT copying transforms and slope matrix	4	93	July 1, 2020
Saving voltage tables	1	54	June 10, 2020
ER-101 voltage tables format	2	106	June 7, 2020
Slope mod affected by gate	7	107	May 9, 2020
ER102 step record: drops out of record after a couple seconds?	3	98	May 8, 2020
Reset only some tracks	3	68	May 8, 2020
Multiple 'reset to' steps per part request	10	363	May 8, 2020
SYNC message on startup	10	410	May 7, 2020
V2.xx: ER-102 Firmware Discussion feedback	78	4915	April 30, 2020
ER-102 parts availability	4	433	April 27, 2020
Feature request: Coupled tracks, patterns or notes request	1	63	April 10, 2020
Copy pattern through snapshot	18	631	February 26, 2020
Set CV Slope behaviour per Channel in config.ini request	8	682	February 26, 2020
Alter Record and Group Quantize on Duration support	2	93	February 22, 2020
Step Time Gate/Dur values	2	92	February 20, 2020
Multitrack recording	3	200	January 6, 2020
Grey or black buttons	2	193	December 23, 2019
ER 102 group modifier - feature request request	3	137	December 21, 2019
Part loop length? support	1	90	December 12, 2019
ER-102 Group modifiers	9	929	November 18, 2019
Ia there a limit to the SD card for the ER-102?	1	118	November 1, 2019
Feature Request: Trigger Rotate/Invert with CV request	16	493	October 19, 2019