Here’s the Custom Unit Preset with JUST the sin sound source:
All you have to do is add a custom unit and load the preset:
4stepsin.lua.zip (5.5 KB)
1/V pitch is expected at A1
Step on/off, Pitch grab, and release time can be controlled from the front of the custom unit - or use below which is setup to expect a gate:
Steps 1 to 4 on/off toggle: GATE 1 - 4
Steps 1 to 4 pitch grabber: A2, B2, C2, D2
Steps 1 to 4 Release time: A3, B3, C3, D3
NOTE: Be sure that when when switching steps, to select a different direction and NOT turn off the current step so no steps are lit. If that happens the modes freak out (oops). If this happens (all steps light up), turn off the <-> step then turn off and on the <<< step and you’ll be ok.
CONTROLS:
Volume: Pre-Delay volume of entire patch
Delay: Wet/Dry of tempo delay
1v/o: Pitch input
Speed: Speed of sequencer
← backwards steps
<–> pendulum steps
→ forward steps
Grab1: assign pitch to step 1
Grab2: assign pitch to step 2
Grab3: assign pitch to step 3
Grab4: assign pitch to step 4
On 1: Step 1 on/off
On 2: Step 2 on/off
On 3: Step 3 on/off
On 4: Step 4 on/off
Rel 1: Release time for Step 1
Rel 2: Release time for Step 2
Rel 3: Release time for Step 3
Rel 4: Release time for Step 4
Step: No touchy this fader!! This is a container for the stepping modes so they show up as a local signal