ER-101 state question

Hello All,

Two times recently I’ve managed to get my ER-101 into a state that I can’t escape from. Unsure if these are bugs or user error. But if anyone knows I’d like know :smile:

I have firmware 2.09 (F2.09 flashes on the voltage display on start up).

This was after copying and inserting a pattern, then switching back to follow mode. The sequence is running fine, but CV A, B, duration, and gate all stuck displaying ‘–’. Switching to edit/hold modes they remain on ‘–’ and I can make any edits.

The next one I’m not actually sure what I was doing (I think it was something with math). But got this and couldn’t escape: