Home | ER-101 | ER-102 | ER-301 | Wiki | Contact

Er-301 scope


#1

Can the scope Mode (or any other Mode) Show the frequency of incoming signals? (A la tuning)

2d


#2

i think it is a future feature : Tuner unit?


#3

Yes, the tuner unit is a future feature. It is however already possible to get quite a reasonable frequency readout with the pulse to hz unit or similar units that measure a pulse (clocks etc.). You can definitely get close enough to do the final bit of tuning (i.e. the last few cent) by ear.


#4

Sounds like this will work in the meantime! Thanks!


#5

x2mirko, could you maybe elaborate on what you mean? I can’t see how I can get the pulse to be anything other than the internal input?

2d


#6

Maybe I just don’t understand what you’re trying to do. Here’s the most trivial setup I can think of: Aliasing saw oscillator straight into Pulse to Hertz. Substitute the oscillator with the signal you wish to tune.

0007