Home | ER-101 | ER-102 | ER-301 | Wiki | Contact

I2c problems and a strange a pin


Hi all,
In the last days i had a faderbank 16n and a sweet sixteen by Tessaract.
Both of them work perfectly via cv but with i2c they won’t work, first I double check the external controllers and then looking to my er and i found a ground pin bent over touching the metallic part of the shaft of the encoder (see pic) and then i tried with a multimeter and found that there is a continuty between the gnd and the sda.
Is it normal @odevices?

2 posts were merged into an existing topic: I2C setup with 16n Faderbank