Home | ER-101 | ER-102 | ER-301 | Wiki | Contact

My ER-101 won't loop

Hello,
I have a loop start and end defined. But my er-101 won’t loop! What could be causing it to ignore the loop start and end and go through the whole sequence?

(the start and end are set on one step, but it ignores that and goes through all the steps)

I know it was an older topic but I have the same problem and don’t know why my ER-101 don’t want loop.
Is there an option which “lock” my ER-101 sequence and avoid me to loop ?

Thanks,
Jeremy

Are you in HOLD mode with your loop changes uncommitted?

or

Are you editing a different PART then the one that is active?

That’s it ! I was editing a different PART the the one that was active.
Thank you a lot for your help :slight_smile: