Setting a note to zero

Is there a way to “reset” a note value (or a sequence of note values) without turning the selector knob? Like, to zero? Maybe I would just need to fill the clipboard with a zero value or similar? Or I guess I could multiply by zero…

MATH transforms (multiply by zero) are the intended way. :cat:

1 Like

And if I want to apply this transformation to a sequence of notes, defined by the loop start and end points?

Unfortunately this only possible with the ER-102 because you can focus a PART and apply a MATH transform to it. :bow:

1 Like

Need. Will buy soon. $$$

I see that I asked a similar question today. Fine prior minds think alike. :stuck_out_tongue: