Can someone confirm this ‘bug’? Tested on both 48 & 96khz of v0.3.23,
When changing any setting in System Settings, after a short pause, my 301 automatically tries to save to the rear card (the message appears) at which point it freezes until I press a button and it reboots.
This also happens when you press Enter on a system setting option.
With older firmware (I checked on 3.18) , it looks like the system setting change was saved when you came out of the menu.
EDIT: just to add - after the reboot, whichever ‘setting’ I changed does appear to have been changed, so the save is happening (so I don’t think it’s caused by a corrupt rear SD card).
After a bit more testing… If I wait a bit longer before hitting the Up key, it actually doesn’t reboot but seems to lock up on me. I have to power cycle to restore. If I hit Up fast enough, it all seems OK. Something definitely seems amiss here.
And after a little more testing, another time I tried changing a setting and just did one up (to get back to settings). Waited a few seconds, and it saved an all was fine. Seems a little hard to produce a consistent result.
In my case, all the testing was done from a fresh boot - nothing else going on.